2012 Ford Fusion Coolant Temperature Sensor Location Buy now!new coolant temperature sensor from 1aauto 1aau.to ia 1atsu00032this video shows you how to install a new coolant temperature sensor in yo. 2012. the 2012 ford fusion has a coolant temperature sensor that can be found by accessing the bottom of your vehicle, or through the hood. first, go to the front of the engine, and open the hood, using the prop arm on the passenger side of the engine bay to secure it in an open position. take a look into the engine bay, toward the center of.
2012 Ford Fusion Temperature Sensor Location 2. region:u.s. mountain. my fusion:2012. posted may 18, 2019. i'm about to change the coolant and at the 62,000 mile mark thought the thermostat and coolant temp sensor would be good preventative replacements. getting an actual location from the 2006 14 chilton repair manual or 2012 service manual dvd have not been helpful. On 3 3 2020 at 4:54 am, flightofthefusion said: so it is the 2.3l and yes, the heater works fine. i originally thought the same thing, that the thermostat was stuck open. but, even on out coldest days (i live in the upper mountains of utah, so it gets pretty cold.) the heater is just fine. 2 12a648 ect sensor. (picture #1) drain the cooling system. for additional information, refer to section 303 03. disconnect the engine coolant temperature (ect) sensor electrical connector. remove the ect sensor. (picture #2) pull upward on the locking tab. rotate the sensor counterclockwise and remove. Instructional video library. thousands of how to auto repair videos to guide you step by step through your repair. this video shows you how to install a new coolant temperature sensor in your 2006 2012 ford fusion (3.0l v6).
2012 Ford Fusion Temperature Sensor Location 2 12a648 ect sensor. (picture #1) drain the cooling system. for additional information, refer to section 303 03. disconnect the engine coolant temperature (ect) sensor electrical connector. remove the ect sensor. (picture #2) pull upward on the locking tab. rotate the sensor counterclockwise and remove. Instructional video library. thousands of how to auto repair videos to guide you step by step through your repair. this video shows you how to install a new coolant temperature sensor in your 2006 2012 ford fusion (3.0l v6). Coolant temperature sensor location replacement 3.5 ford edge flex taurus fusion lincoln mkx mkzin this video we will show you where the coolant temperature. Step 7: remove electronic harness from the temperature sensor. the first thing is to remove the electronic harness that connects to the sensor. typically this sensor is attached with a plastic clip. to remove the clip, take a flat head screwdriver and slowly pry the clip from the outside edge of the temperature sensor.
Comments are closed.