2012 Ford Fusion Coolant Temperature Sensor Location Buy now!new coolant temperature sensor from 1aauto 1aau.to ia 1atsu00032this video shows you how to install a new coolant temperature sensor in yo. 2012. the 2012 ford fusion has a coolant temperature sensor that can be found by accessing the bottom of your vehicle, or through the hood. first, go to the front of the engine, and open the hood, using the prop arm on the passenger side of the engine bay to secure it in an open position. take a look into the engine bay, toward the center of.
2012 Ford Fusion Temperature Sensor Location Since ford decided to bury a flawed and failure prone sensor deep within the dash of the vehicle, here’s a 45 min 1 hour shortcut that can save you upwards. 2. region:u.s. mountain. my fusion:2012. posted may 18, 2019. i'm about to change the coolant and at the 62,000 mile mark thought the thermostat and coolant temp sensor would be good preventative replacements. getting an actual location from the 2006 14 chilton repair manual or 2012 service manual dvd have not been helpful. Instructional video library. thousands of how to auto repair videos to guide you step by step through your repair. this video shows you how to install a new coolant temperature sensor in your 2006 2012 ford fusion (3.0l v6). 1 answer. detach the cylinder head temperature (cht) (#1 on image) sensor cover and position aside. disconnect the cht sensor electrical connector (#2). remove the cht sensor (#3). to install, tighten to 12 nm (106 lb in). to install, reverse the removal procedure. how to remove the temperature sensor on the 2012 ford fusion 2.5l?.
2012 Ford Fusion Coolant Temperature Sensor Location Instructional video library. thousands of how to auto repair videos to guide you step by step through your repair. this video shows you how to install a new coolant temperature sensor in your 2006 2012 ford fusion (3.0l v6). 1 answer. detach the cylinder head temperature (cht) (#1 on image) sensor cover and position aside. disconnect the cht sensor electrical connector (#2). remove the cht sensor (#3). to install, tighten to 12 nm (106 lb in). to install, reverse the removal procedure. how to remove the temperature sensor on the 2012 ford fusion 2.5l?. Answered feb 14, 2018 by carguy1 (13.6k points) best answer. hi there. the cht sensor is mounted in the center of the cylinder head between the ignition coils. cannot find the location of the coolant temp sensor on my 2012 fusion. 4 cyclinder. Step 1: be sure the engine is cool. locate the main pressure cap for the cooling system and open it enough to relieve any pressure in the cooling system, then reinstall the cap so it seals properly. step 2. locate the coolant temperature sensor. many engines have multiple sensors that look similar to each other, so an investment in either a.
Comments are closed.