Bleeding The Air From Cooling System In Your Dodge 4 7о Just a quick video explaining how to bleed the air out of your cooling system a very important procedure especially on this truck. How to bleed air out of the coolant system on a dodge jeep 4.7l engine after replacing a water pump radiator or antifreeze hosethis was on a 2007 commander#b.
How To Bleed A Radiator Jeep Dodge 4 7l Youtube This is the best way i found to effectively bleed all the air out of the coolant system of the 4.7 chrysler engine. i hope this is helpful.as an amazon assoc. Standard procedure refilling cooling system 4.7l engine. tighten the radiator draincοck and the cylinder block drain plugs (if removed.) caution: failure to purge air from the cooling system can result in an overheating condition and severe engine damage. remove the cooling system bleed plug from the radiator upper hose inlet housing. When i put in my second thermostat, i also drilled a small hole, either 7 64 or 9 64 directly opposite the one with the one way vent in the flange, because i wanted to ensure the air would get moved. in the cooler months, it can take slightly longer to warm up. but it's not a significant difference. new fan clutch arrives friday. 1.with your truck being cold. 2.remove the rad. cap 3.start your truck. 4. let it idle till the t.stat opens. ( this will take a bit so grab your drink of choice) 5. have coolant there with you ( not a good drink of choice ) after the t. stat opens it will "puck out some coolant , refill the system.
Comments are closed.