Chevrolet Venture Overheating Cooling Fan Problems And A Complete Troubleshooting Procedure

chevrolet venture overheating cooling fan problems and A Comp
chevrolet venture overheating cooling fan problems and A Comp

Chevrolet Venture Overheating Cooling Fan Problems And A Comp Complete troubleshooting. this video shows how to check the fan motors, all electrical circuits, and how to test the relays and pcm. Venture: overheating when idling causes and solutions. 1. low coolant. while it seems counter intuitive, when your venture is low on coolant may run ok with wind hitting the radiator, but when idling there’s just not enough coolant to properly cool the engine. solution: fill the radiator and coolant reservoir back up.

2003 chevy venture overheating problems
2003 chevy venture overheating problems

2003 Chevy Venture Overheating Problems Here are the most common symptoms that your chevy venture is overheating. 1. gauge temp light. your venture will be equipped with a temperature warning light and or a temperature gauge. the most common symptom of overheating is the temperature light coming on. if this light does come on, make sure that you get off the road quickly and safely. Cooling systems are far more sophisticated today than they were decades ago. but the problems we had back then — like overheating — can still ruin a weekend. cooling systems during the muscle car era were basic. if the pressure inside the radiator got too high, the system would vent to the atmosphere (i.e., the ground). If the level is low, add the proper coolant water mixture to fill the radiator. crank the venture’s engine and run the vehicle until the coolant begins to circulate and check the level again. using the flashlight, check the radiator tanks and the radiator hoses for leaks. 2. check the radiator cap by removing it while the venture is cool. 2003 chevy venture overheating issues. maintenance repairs. theroadshowguy august 12, 2012, 12:17am 1. i have been chasing this overheating problem for a couple of months now, and i am thoroughly frustrated. the first issue was a hole in a short, s shaped hose that goes from the the air bleed valve on the top of the water pump, to a metal line.

Comments are closed.