Diy Dryer Restoration Cleaning And Resurfacing A Rusted Dryer Using Offical Orange

Diy Dryer Restoration Cleaning And Resurfacing A Rusted Dryer In this video we use official orange and green scotch brite scrub pads ( amzn.to 3iyyumh) to remove most of the rust and oxidation built up on a drye. Step 1: sand the dryer to remove existing rust stains. use coarse grit sandpaper to remove rust spots from the top of the dryer. an 80 grit sanding sponge is fantastic for removing stains from the top or sides of the dryer. a finer grade sandpaper is recommended for any corrosion on corners or in crevices. for more stubborn rust, use a wire.

Diy Dryer Restoration Cleaning And Resurfacing A Rusted Dryer Take your sander block and sand the rusty scraped areas until smooth. 2.wipe dryer clean. using your microfiber cloth, make sure to clean the area to be painted well. don’t leave any particles behind!! you don’t want to have little bumps all over your new white dryer top. 3.tape off vent areas you don’t want to paint. Air duct. the primary reason that a dryer deposits rust stains on items is that there is rust present in the dryer that is transferring to clothes. the first place to check is the air duct, which is located in the right side of the rear of the dryer. use an old towel to wipe the air duct clean. if rust comes off on the towel, disconnect power. For example: search “maytag 001122 dryer specifications .pdf” and you should be able to find the material. if you find out that’s it’s not like some cheap aluminum. you may be able to use citric acid to clean the rust i would recommend protective gear like gloves and goggles when dealing with an acid though. Remove the screws, then pull the top toward you and lift it off. to open the bottom panel, release the spring catches by shoving a putty knife into the slot just above them. with the bottom panel open, you can remove the front panel by removing two screws at the top and two at the bottom. if your filter slides into the top of the dryer, remove.