How To Change An Engine Oil Filter Step By Step Guide Natrad Tighten with your hand and then secure with the socket wrench. make sure to not over tighten. your owner’s manual may indicate the use of a new drain plug gasket. it’s best to check if this is the case before starting the oil filter replacement process. if so, place it onto the drain plug and tighten. 3. tighten the new filter 1 4 to 3 4 of a turn. give the new filter another partial twist, no more than 3 4 of a twist, to finish tightening it. only do this part by hand as well. [10] if you notice the oil filter still leaking after you tighten it, then give it 1 4 of a turn more until it is leak free. 4.
How To Change An Engine Oil Filter Step By Step Guide Natrad Step 6: fill it back up with oil. once you have replaced the oil filter and drain plug, reinstall your undertray and lower the car back to the ground. open the hood and remove the oil cap, which. Install the new oil filter: apply a small amount of oil to the rubber gasket on the new oil filter, then screw it onto the engine by hand. tighten the filter by hand or with a wrench, being careful not to overtighten. at fram, we design most oil filters with a non slip textured grip. the fully textured surface makes installation and removal easy. Drain the oil into a pan and replace the oil plug. run your engine for a few minutes to warm up the oil before doing this. turn the engine off before starting. 2. remove the filter with an oil filter wrench. if you don’t have a specialized wrench, you could attempt to take it off by hand, but make sure it’s not hot. Tighten the plug by hand or use a wrench to snug it up. never over tighten the plug. 4. locate the oil filter. if you are unsure of the location, check your owner’s manual. 5. move the oil drain pan underneath the filter. 6. grab and twist the filter to remove.
Comments are closed.