How To Check Or Refill Engine Coolant Antifreeze Types Of Coolantsо How to check & refill engine coolant antifreezeeasy do it yourselfthanks for watching. awkwardhamster twitter awkwardhamster w. Funnel: amzn.to 2wajopecoolant antifreeze: amzn.to 2kdcemnsupport this channel so i can make more great 4runner videos (paypal): otcslappys@h.
How To Check Refill Engine Coolant Antifreeze Youtube In this episode of proctor car tips, jeremy from proctor acura speaks about the engine coolant antifreeze system and how to check or change it. he also discu. The radiator uses a series of tubes and hoses to transport coolant, or antifreeze, and cool down your engine. without enough coolant, your engine may overheat. engine cooling system problems could arise if you don’t have the right mixture of coolant, which is typically a 50 50 mix of antifreeze and water. finally, a leak in the system could. With a cold engine, add coolant to the full or cold mark. to get rid of as much air as you can during the fill, squeeze the upper radiator hose to ‘burp’ the system. repeat it a few times until there aren’t any air bubbles heard or felt in the hose. 5. install the cap. Make sure you find the right tank (adding antifreeze to the screen wash, brake fluid or power steering reservoir could cause damage). check your vehicle handbook to find the location of the coolant filler cap. 3. check the engine coolant level. the coolant should be between the min and max marks on the side of the expansion tank.
How To Check Coolant Refill Engine Coolant Antifreeze Toyota Ava With a cold engine, add coolant to the full or cold mark. to get rid of as much air as you can during the fill, squeeze the upper radiator hose to ‘burp’ the system. repeat it a few times until there aren’t any air bubbles heard or felt in the hose. 5. install the cap. Make sure you find the right tank (adding antifreeze to the screen wash, brake fluid or power steering reservoir could cause damage). check your vehicle handbook to find the location of the coolant filler cap. 3. check the engine coolant level. the coolant should be between the min and max marks on the side of the expansion tank. Insert the tubular end of your hydrometer into the coolant. squeeze the rubber bulb, filling the transparent plastic body of the hydrometer with coolant. examine the floating indicator inside. it will point at a certain number printed on the tool based on the coolant’s density. Turn your engine off and let it cool down for 15 minutes, then pop the hood and locate the coolant reservoir near the engine. uncap the coolant reservoir and use a funnel to add coolant to the reservoir up to the “max” or “fill line” indicators on the side. replace the coolant cap and let the car idle for 5 minutes while you check the.
Comments are closed.