How To Check Your Cars Coolant Level Youtube Step 2: pop the hood and locate the radiator cap. open your car’s hood. almost all cars have their radiators located under the hood. once the hood is opened, look to the front of the engine bay. Open your hood and locate your radiator and coolant reservoir. some older vehicles don’t include a reservoir, but most modern vehicles have a small tank for filling and checking the coolant level. the reservoir should be clear plastic, so you can easily see the level of coolant and the maximum fill line.
How To Check Your Coolant Level Youtube 1. park the car on a level surface. if the car is not level, for instance if it is parked on a hill, you cannot get a true reading of your coolant level. in fact, if you open up your radiator cap while parked on a hill it could cause coolant to pour out. [1] 2. make sure the engine is cool. There are two places under your hood to check coolant level: the overflow tank (which some old cars may not have) and the radiator itself. if it’s not obvious, you can find the overflow tank by. Park the car on a flat surface and pop open the hood. 1. locate your coolant overflow reservoir. 2. you will see terms such as "full" and "low," which indicate how much coolant is in the system. 3. use a funnel to fill up the reservoir until it reaches the "full" status. 4. replace the cap and close the hood. In order to remove this air from the system, keep the ignition key in the on position for at least 10 minutes without starting your engine. after 10 minutes, switch off the ignition and wait for about 5 minutes to release any remaining pressure through the filler cap. 9. recheck coolant level.
How To Check Your Car S Coolant Level Natrad Park the car on a flat surface and pop open the hood. 1. locate your coolant overflow reservoir. 2. you will see terms such as "full" and "low," which indicate how much coolant is in the system. 3. use a funnel to fill up the reservoir until it reaches the "full" status. 4. replace the cap and close the hood. In order to remove this air from the system, keep the ignition key in the on position for at least 10 minutes without starting your engine. after 10 minutes, switch off the ignition and wait for about 5 minutes to release any remaining pressure through the filler cap. 9. recheck coolant level. Test the coolant. set your multimeter to dc volts to less than (<) 20 volts. touch the black lead to the negative battery lead or the chassis ground, and place the red lead into the coolant. if the reading is less than .4 volts, the coolant is in good shape. anything over that indicates the anti corrosive properties of the antifreeze have. Make sure you find the right tank (adding antifreeze to the screen wash, brake fluid or power steering reservoir could cause damage). check your vehicle handbook to find the location of the coolant filler cap. 3. check the engine coolant level. the coolant should be between the min and max marks on the side of the expansion tank.
Comments are closed.