How To Draft The Basic Bodice Pattern The Shapes Of Fabric Start the pattern by drawing these 3 horizontal lines. the first two are 5 cm apart from each other. to draw the uppermost line, measure the distance between the underarm line and the shoulder tip of your bodice back (1) with a straight line. *detract the following cm (=x) from the measurement : size xs: 3,5 cm. Draft the side seam. for simplicity, at this stage, treat the side seam (line a3 a4) as a dart at this point. distribute one third of the dart width to the back of the bodice and two thirds to front of the bodice, either side of a2. join the endpoints to a3 to create the front and back side seams.
How To Draft A Basic Bodice Block Pattern Anicka Design Outline the dart legs with a pencil or marker. transfer the dart to the back pattern piece. at the back the dart is quite narrow and the dart legs the same length. using a tape measure or a flexible ruler, measure the length of the bodice armscye. do not include the dart in the measurement. Step 2: outline the basic bodice pattern. begin outlining the pattern by marking point a on the paper, preferably close to the top right angle. then, from point a down the line measure the nape to waist measurement and mark point b (figure 1). extend 3 5″ (1.5cm) up from point a and mark point c (figure 2). Moving on to drafting the armscye. start by measuring 5 cm (1.9 inches) upwards from the underarm line all the way to the shoulder peak. mark a point at the center of this line. draw the armscye in a curved shape that touches the point you marked in the center, but leaves mm of distance from the shoulder peak. This is a pattern tutorial showing how to draft the basic bodice block pattern. men's basic bodice pattern tutorial here watch?v=0ugx.
Comments are closed.