How To Flush And De Salt Your Outboard Motor Properly Youtube No matter where you boat, if you have an outboard motor, the best thing you can do to help prolong its life and keep it in good running shape is to flush it. This video shows you how to flush your outboard engine using a freshwater hose. it demonstrates two methods. one method utilizes the backwash port without th.
How To Flush And De Salt Your Boat Motor Better Outboards Or Inboards If you own a boat with an outboard motor, you need to understand how to give it a freshwater flush. this is an extremely important outboard maintenance chore. Be sure the engine is receiving cooling water (by checking the overboard indicator). if your outboard has more than one set of cooling inlets, a flush bag should be used. flushing port: engine should not be running; it can be tilted or vertical. prop should be removed. flush for 10 15 minutes. How to flush outboard engines that have a flushing port: remove the cap from the flushing port, and thread your garden hose into it. if the boat is in the water, tilt the engine up until the outdrive has drained of saltwater. turn on the water, and let it run for at least five minutes. do not start the engine. remove the hose, and replace the cap. Place the flushing bag under the lower unit and trim the lower unit down into the bag. fill the bag with water and keep the hose running. next, start the motor and let it idle for about 10 minutes. as it idles, it’ll draw water out of the bag while the running hose replenishes the water level in the bag. turn off the engine, then tilt it up.
How To Flush An Outboard Engine Boatus Youtube How to flush outboard engines that have a flushing port: remove the cap from the flushing port, and thread your garden hose into it. if the boat is in the water, tilt the engine up until the outdrive has drained of saltwater. turn on the water, and let it run for at least five minutes. do not start the engine. remove the hose, and replace the cap. Place the flushing bag under the lower unit and trim the lower unit down into the bag. fill the bag with water and keep the hose running. next, start the motor and let it idle for about 10 minutes. as it idles, it’ll draw water out of the bag while the running hose replenishes the water level in the bag. turn off the engine, then tilt it up. If your engine or drive has low water pickups, tape these closed with duct tape during the flushing so the engine does not suck in air. turn on the water to medium high and start the engine. if water does not discharge through the exhaust or telltale after a minute, shut down and look for a blockage. more: boat maintenance, engines, how to. Here’s the good news: flushing with freshwater is a simple task, and this mercury quick tip video will show you how. all you have to do is lower your engine to the vertical position, hook up a hose to the conveniently located flush connector and let the water run for 10 minutes – you don’t even have to start your engine. by the time you.
Comments are closed.