Diy Board And Batten Wall Diy And Home Decor Domestic Blonde Install the new baseboard. attach a one by four board along the base of the wall to replace the old baseboard. nail the board to the studs with the brad gun. the board should remain 1 4 inch above the floor. adjust for floor level variations by installing the baseboard level with the help of the bubble level. To make this easier, add the width of the trim to the distance between each batten. i.e. if your trim is 1.5″ and your battens are 12″ apart, mark the wall every 13.5″. finish up by hanging each batten (a level is key once again). if you are doing an entire room, repeat this process on the rest of your walls. 4.
Board And Batten Wall San Diego Diy Domestic Blonde Step 4: install the top board. for the top board, we used a 1×3, but you could also use a thinner board here as well if you wanted your battens and the top board to be flush. before installing the top board, mark the studs. since this board spans all the way across the top, you can actually install it into the studs. Step 1: pick a layout control point. measure and mark the center of your feature wall. next, measure to each intersecting wall as if the center of the center board is on the layout mark on the. Attach to the wall with constuction adhesive and 1 1 4"brad nails. add the top 1x2 board on top of the middle board to create a ledge. install with 1 1 4″ brad nails and some construction adhesive. fill nail holes with spackle and caulk all the seams. prime the board and batten if boards aren't pre primed. 2. measure and cut your boards and battens. next, measure and cut your horizontal trim boards with a cross cut saw and install them carefully on the wall with a finishing nail gun. use a stud finder to nail the trim into the studs in your wall. i used a measuring tape and a level to ensure my trim was straight.
Comments are closed.