How To Replace Radiator Cooling Fan And Clutch 1990 2004 о Buy now!new radiator cooling fan blade from 1aauto 1aau.to ia 1arfa000951a auto shows you how to repair, install, fix, change or replace a broken. Step 1 :removing the intake tube. 1:01. remove the phillips head screws from the throttle body cover. remove the 7mm bolt from the throttle body cover. loosen the two clamps on the intake hose. remove the intake tube. step 2 :removing the radiator fan and shroud. 2:00. remove the 36mm fan clutch nut.
How To Replace A Fan Clutch Youtube This has worked great for me over the years, and hope you have the same experience. simple, free and doesn't require special tools. let me know how it works. Clueless spectator! fan clutch removal, a new trick! i had my welder with me today, and i was going to make a gizmo to hold the water pump pulley in order to unscrew the fan clutch. i had the motor out, so it was easy to get a good look at it and realized that this would work great. just take a large open end wrench, i used a 7 8 but any wrench. Sometimes you don't need a special tool and things just come off easily. other times it's a pia. try this first, all you need is a hammer, wrench, and flat h. Allow approximately 5 10 minutes for the temperature to become high enough to engage the fan blade clutch. this will be indicated by an increase, or roar, in fan air noise and by a drop in the thermometer reading of about 3 10°c (5 15°f). if the clutch did not engage between 65 90°c (150 195°f), replace the assembly.
Comments are closed.