How To Test Your Smoke Detector Regularly testing your smoke alarm could potentially save your life. here's a little hack to stop you from getting a set of ladders out when you want to test. A working smoke alarm in your home could save your life in the unfortunate event of a fire. in this video, matt from bunnings warehouse talks through the dif.
How To Test A Smoke Alarm Diy At Bunnings Youtube Depending on the brand of alarm you’ve chosen, follow the set up directions to connect them all together. to test this, activate one smoke alarm as the master alarm. press the test button three times until a red light appears on the back, followed by a blue light. for all secondary alarms, press the test button three times until a red light. Having a functioning smoke alarm in your home is one of the top priorities when it comes to safety and is required by law. the cfa recommends a smoke alarm b. If your smoke heat alarm does not sound during testing: • check that your device is activated. • if testing after first installation, allow a few seconds for the alarm to settle. • to hear the alarm at full volume double press the test button. • if the alarm has been silenced and is in low sensitivity mode it may not test. Press and hold the test button on your smoke detector for a few seconds. if the alarm sounds, the detector is working. if it doesn’t, replace the batteries or check the wiring for damage. then, test the sensors by spraying a smoke detector tester spray around the device. repeat these steps at least once a month.
Comments are closed.