Making Clay Trinket Dishes And Magnetsрџќірџќ рџќ Using Airођ Social,@gazoostudio on instagram and tiktoktime stamps :preview 0:00preparation 0:15shaping the clay 0:45sanding process 7:05sticking the magnets 7:33paintin. Roll out the clay and from different directions. roll evenly, until it is about 1 4″ thick. if you need to start over, just ball it up and then roll it out again. if there are a lot of cracks in the shape ball it up a bit more compressing it in your hands or on the table as you do so. this is called wedging the clay.
I Had So Much Fun While Making These Clay Trinket Dishes And Magnets р Step by step instructions: 1. get a good chunk of air dry clay and mold it between your hands for a couple of seconds. 2. cut two pieces of plastic wrap (slightly larger than your stencil). 3. roll out the clay between the sheets to a 1 8 – 1 6 inch thickness. 4. remove the upper sheet and smooth out any wrinkles. Social,@gazoostudio on instagram and tiktoktime stamps :preview 0:00preparation 0:15shaping the clay 0:34sanding process 10:44painting process 11:03finishing. Social,@gazoostudio on instagramtime stamps :preview 0:00preparation 0:17shaping the clay 0:40fixing the cracks 10:16sanding process 11:29painting process 11. Social, @gazoostudio on instagram and tiktok time stamps : preview 0:00 preparation 0:15 shaping the clay 0:45 sanding process 7:05 sticking the magnets 7:33 painting process 7:52 coating process using uv resin and glossy varnish 14:10 final result 17:02 materials that i used on this video : jovi air dry clay amzn.to 3giof7b clay.
Eyes Staring At You Blue Trinket Dish 3 Etsy Canada In 2024 Social,@gazoostudio on instagramtime stamps :preview 0:00preparation 0:17shaping the clay 0:40fixing the cracks 10:16sanding process 11:29painting process 11. Social, @gazoostudio on instagram and tiktok time stamps : preview 0:00 preparation 0:15 shaping the clay 0:45 sanding process 7:05 sticking the magnets 7:33 painting process 7:52 coating process using uv resin and glossy varnish 14:10 final result 17:02 materials that i used on this video : jovi air dry clay amzn.to 3giof7b clay. Shaping the dish. step 3: cut out the cherry blossom shape: place your hand drawn cherry blossom template over the rolled out clay and carefully cut around it. the air dry clay project template makes achieving the perfect cherry blossom shape for your trinket dish easy. step 4: stamp in the stamen: use a bent paperclip and a round drawing pin. Lay cling film over the air dry clay, then using a rolling pin, roll over the clay to create a flat slab. keep rolling until the slab is flat. unwrap the cling film. grab a circular dish and cut around the clay with a knife to form a circle. remove the dish and pull the clay off slightly. mould the edges to form an edge.
Comments are closed.