Relearn Tpms On Gm Vehicles Without A Tpms Tool Youtube In this video after i rotate tires i show how to relearn tpms on a 2011 volt and other gm vehicles without a tpms tool.disclaimer:i am not responsible for. Today im going to show you how to relearn the tpm or tire location on this chevy trailblazer with out a scan tool hope this helps!! check out the new mer.
Program Tpms Sensors Without A Tool 2007 2014 Chevrolet Gmc Vehicles All the steps must be followed. don't forget to set the parking brake, key in run not started, then press lock & unlock on the keyfob. the horn will beep twice and tire learning active will display. that's for my 2010 but i don't think they've changed it. there is an alternative process if you don't have keyfobs. Access the tpms menu: start your vehicle and navigate to the tpms option on your dashboard or infotainment system. this might be under ‘settings’ or a similar menu. initiate “learn” or “program” mode: once in the tpms menu, look for options like “learn mode” or “program sensors.”. The following relearn process takes up to 10 minutes of driving with a speed of minimum 12 mph. in this case can be displayed or pressure values can swap in the dic. if problems occur during the relearn process a warning message is displayed in the dic. notice vehicles equipped with the auto learn function do not allow manual sensor matching. In this short video i show you how to reprogram the tpms on most '07 up gm vehicles after a tire rotation with out using a factory scan tool. this procedure.
Comments are closed.