Sbc 305 350 Cylinder Head Rebuild Part Two Youtube Part two of the 305 350 sbc refresh rebuild video series, in this video i lap the valves and clean the headsi’ve had some people ask for my address to send a. I am cleaning up a set of heads, this is part one of two. taking the heads apart, cleaning the gasket surfaces and ports, cleaning the valves. check back for.
Sbc 305 Vortec Heads This is the third and final part of rebuilding a set of chevy cylinder heads, they're done and they came out awesomei’ve had some people ask for my address t. If you fall into that category, listen carefully. the most important part of your cylinder head is, as per fig 6 3 and fig 6 4, the area 1 inch before the valve seat to 1 2 inch after it on the intake and vice versa on the exhaust. be aware that what you think is needed may not be what is wanted. We’ve already established the valve to guide clearance, so the next step is to measure the valve spring installed height. this is the distance from the spring seat in the head to the bottom side of the retainer where the spring seats. the stock dimension for a small block chevy is 1.780 inches. They are basically a copy of the zz4 intake but with a vortec head pattern. the one that came on my volvo penta still had the chevy emblem cast in the front and the chevy casting number. i will also suggest that you get a spreadbore intake. just in case you decide on a different carb later, a spreadbore intake will accept a spread or squarebore.
Comments are closed.